MIL-DTL-15024F
3.4.3.2 Marking method. All characters shall be marked on the plate by stamping.
Additional information may be permanently stamped.
3.4.3.3 Dimensions. Characters shall be not less than 0.003-inch deep. The thickness of
type C plates shall be not less than 0.03 inch.
3.4.4 Type D.
3.4.4.1 Materials. Type D plates shall be of cast metal. Cast brass or bronze of commercial
quality is recommended, but not mandatory.
3.4.4.2 Marking method. All characters shall be raised above the body of the plate and shall
be smooth and free from burrs and sharp edges. The balance of the plate shall have a roughened
or stippled finish. Additional information may be permanently stamped on raised pads provided
for this purpose.
3.4.4.3 Dimensions. Characters shall be raised not less than 0.03 inch. The thickness of
type D plates shall be specified in the contract or purchase order (see 6.2). When it is not
specified in the specification sheet, the thickness may be the manufacturer's standard.
3.4.5 Type E.
3.4.5.1 Materials. The following materials are recommended, but are not mandatory:
a. Brass.
b. Corrosion resistant steel.
c. Aluminum alloy.
d. Plastic.
Type E plates may be fabricated from a MIL-M-43719 Type I adhesive backed film adhered to
aluminum alloy sheet conforming to QQ-A-250/8. Type E plates shall only be used in areas
protected from the environment.
3.4.5.2 Marking method. Marking shall be applied by litho printing, or screen. A protective
coating of compatible fungus-resistant, moisture-resistant clear varnish may be applied over the
marking.
3.4.5.3 Dimensions. The thickness of the plate shall be not less than 0.03 inch.
9
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business